When is a different start code allowed? - E1.20 RDM (Remote Device Management) Protocol Forums

prwatE120 · August 28th, 2008

Hi

I am responsible for the RDM demo areas at both PLASA and LDI.

These displays specifically aim to show interoperability between multiple manufacturers and iron out areas of differing interpretation of the standard.

If you (or Scott) contact me off list with the details, I will also try and educate the companies concerned.

Whilst there are a small number of products shipped by Howard Eaton Lighting that used the draft RDM start code, we made no claims that they were compliant with the final standard, and any customer is welcome to contact us for an appropriate upgrade.

Peter Willis

August 28th, 2008	#6
prwatE120 Task Group Member Join Date: Jun 2006 Posts: 181	Educating Manufacturers Hi I am responsible for the RDM demo areas at both PLASA and LDI. These displays specifically aim to show interoperability between multiple manufacturers and iron out areas of differing interpretation of the standard. If you (or Scott) contact me off list with the details, I will also try and educate the companies concerned. Whilst there are a small number of products shipped by Howard Eaton Lighting that used the draft RDM start code, we made no claims that they were compliant with the final standard, and any customer is welcome to contact us for an appropriate upgrade. Peter Willis

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sub-device response to SET/GET DMX512 start address	p_richart	RDM Interpretation Questions	2	September 29th, 2006 09:27 AM
Slot Label Code	anstein	RDM General Implementation Discussion	1	August 10th, 2006 02:06 PM