Question about resetting sensors - E1.20 RDM (Remote Device Management) Protocol Forums

sblair · March 7th, 2011

The 2011 version is beyond change at this point. It basically means starting the process all over again.

We did make changes in the 2011 version in this area. The following sentence was added to Lowest and Highest Detected values as well as the Recorded Value: "If this value is not supported, then this field shall be set to 0x0000."

As Eric said, a controller can determine whether a responder supports the functionality by looking at the bit field in the Sensor Definition message and if they are not supported then we have explicitly said what the fields should stuff now.

March 7th, 2011	#5
sblair Administrator Join Date: Feb 2006 Posts: 441	The 2011 version is beyond change at this point. It basically means starting the process all over again. We did make changes in the 2011 version in this area. The following sentence was added to Lowest and Highest Detected values as well as the Recorded Value: "If this value is not supported, then this field shall be set to 0x0000." As Eric said, a controller can determine whether a responder supports the functionality by looking at the bit field in the Sensor Definition message and if they are not supported then we have explicitly said what the fields should stuff now. __________________ Scott M. Blair RDM Protocol Forums Admin

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Reset sensor data of all sensors	sjackman	RDM Interpretation Questions	1	January 20th, 2008 06:47 PM