Relative frequency of UID set changes to RDM messages events - E1.20 RDM (Remote Device Management) Protocol Forums

sblair · July 6th, 2010

When a system is up and running you'll find that it is very stable with few UID changes.

There are two major points where you'll see a lot of UID change chaos happening though:

1. When a system is getting powered up for the day, as each part a system is powered on you'll see a lot of UID list changes. This also includes setting up a system for a one-off show.

2. When troubleshooting a system. At that point you'll see cables being swapped around and plugged in and out, so that will result in a massive amount of UID's coming off and online.

Hope this helps.

July 6th, 2010	#7
sblair Administrator Join Date: Feb 2006 Posts: 441	When a system is up and running you'll find that it is very stable with few UID changes. There are two major points where you'll see a lot of UID change chaos happening though: 1. When a system is getting powered up for the day, as each part a system is powered on you'll see a lot of UID list changes. This also includes setting up a system for a one-off show. 2. When troubleshooting a system. At that point you'll see cables being swapped around and plugged in and out, so that will result in a massive amount of UID's coming off and online. Hope this helps. __________________ Scott M. Blair RDM Protocol Forums Admin

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ACT_TIMER to Set messages	nic123	RDM Interpretation Questions	3	April 18th, 2014 12:01 PM
DISC_UNIQUE_BRANCH dest UID (section 7.3)	berntd	RDM Interpretation Questions	5	October 15th, 2008 09:06 PM
Sub-device response to SET/GET DMX512 start address	p_richart	RDM Interpretation Questions	2	September 29th, 2006 09:27 AM