E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM General Implementation Discussion

RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product.

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old September 1st, 2011   #1
eldoMS
Junior Member
 
Join Date: Aug 2011
Posts: 8
Default Detailed questions on STATUS_MESSAGES

Hi

I have a question with regards to properly implementing and interpreting GET STATUS_MESSAGES.

I understand from the RDM2006 errata that there can be two types of RDM protocol support: either supporting or not supporting Status Type _CLEARED responses.

From a responder point of view, when I have a malfunction of some sort, e.g. a too low bus voltage or a too high temperature I can report this in a GET STATUS_MESSAGES reply with message(s) of a certain type and data values.

Several questions I have then from a responder viewpoint:
- how do I know _CLEARED is supported in the controller, or are most controllers already on that level? A controller without the support just ignores gracefully?
- do I only report once a certain failure (when it arises)? Or consistently with each STATUS_MESSAGE when _CLEARED is not supported? And if I need to report it consistently, how often?
- in the case of _CLEARED I only report ONCE that a certain condition was cleared?
- the PID CLEAR_STATUS_ID, what does it exactly do in this case? Is it a reset of the condition, that in a sticky example immediately comes again with a voltage or temp error and there will be another reporting of this in the next STATUS_MESSAGES (one time only?). Is this the controllers method to clear conditions and create a fresh list? How often could a controller do this? The _CLEARED method is used to remove a warning/error from the controller as soon as it is cleared instead of going via CLEAR_STATUS_ID?

Thanx

Marc
eldoMS is offline   Reply With Quote
 

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
STATUS_MESSAGES berntd RDM General Implementation Discussion 17 October 20th, 2009 10:05 PM
Cable shield connection questions berntd RDM Physical Layer/Hardware Discussion 0 May 25th, 2008 11:22 PM


All times are GMT -6. The time now is 10:29 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.