E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM General Implementation Discussion

RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product.

Reply
 
Thread Tools Search this Thread Display Modes
Old May 8th, 2008   #1
berntd
Senior Member
 
Join Date: Jan 2008
Posts: 102
Default Master Fader accross Rdm implementation Question

Hello,

I have some (dimming) devices here that I can link with Rdm to a controller.
The output of the device channels is essentially still controlled by DMX from the controller and/or the actual faders on each device.

As these things progress, the controller's master fader (grand master)should now also control the fader outputs of all devices in the chain.
i.e replace the master fader on each device.

This means I have to somehow disable/replace the info from each device's master fader with info from the controller.

I am now wondering what the best/easiest/ most reliable way to do this would be.
Has anyone done something like this before?

Should I create Manufacturer specific PIDs for this?


Kind regards
Bernt
berntd is offline   Reply With Quote
Old May 9th, 2008   #2
sblair
Administrator
 
Join Date: Feb 2006
Posts: 419
Send a message via AIM to sblair Send a message via MSN to sblair
Default

Bernt,

There are lots of ways you can tackle this. If the devices are normally going to be used with your own controller then you can easily do this with a Manufacturer-specific PID in RDM.

If it is a case where you typically are going to be relying on someone else's controller, then doing it through plain DMX might make the most sense. You could look at the individual channels and do either an LTP or HTP merge in your device between DMX and the local fader to determine whether the controller or the device has control. You could also use another channel in DMX that the controller can wiggle to take or release control over the device as well.
__________________
Scott M. Blair
RDM Protocol Forums Admin
sblair is offline   Reply With Quote
Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Partial RDM implementation? svanciel RDM General Implementation Discussion 7 November 7th, 2008 08:19 AM
Welcome to the RDM General Implementation Discussion Forum sblair RDM General Implementation Discussion 0 May 31st, 2006 11:38 PM


All times are GMT -6. The time now is 03:20 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.