|
|
|||||||
| RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product. |
|
|
Thread Tools | Search this Thread | Display Modes |
August 27th, 2008
|
#1 |
|
Senior Member
Join Date: Jan 2008
Posts: 102
|
When is a different start code allowed?
Hello all
I have 2 products here that state that they both comply with RDM but when I try to detect the responder with my controller, nothing happens. In fact, my sniffer does not even detect any RDM packets if these 2 units communicate. I then looked at the data manually and found a start code that is not 0xCC. Could someone please clarify when it is allowed to state RDM on a product but use a non RDM start code for all packets? If this is permissable, then who assigns these other start codes and under what conditions? Kind Regards Bernt |
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sub-device response to SET/GET DMX512 start address | p_richart | RDM Interpretation Questions | 2 | September 29th, 2006 09:27 AM |
| Slot Label Code | anstein | RDM General Implementation Discussion | 1 | August 10th, 2006 02:06 PM |
Threaded Mode