BREAK timing at the receiver - E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums

		E1.20 RDM (Remote Device Management) Protocol Forums > RDM User Forums > DMX512 Discussion
BREAK timing at the receiver

Mark Forums Read

DMX512 Discussion Discussion and questions relating to DMX512-A and DMX512/1990.

Search this Thread

Prev

Previous Post

Next Post

Next

November 8th, 2018	#1
zano_villa Junior Member Join Date: Jan 2014 Location: Treviso, Italy Posts: 17	BREAK timing at the receiver Hello, This is the my question: can a DMX receiver consider a signal low level lower than 88us as a BREAK? If the answer in NO, this is a framing error (stop bit error): in this case may the receiver accept previous slots of the frame? DMX512-A 9.1 says it must only discard improperly framed slot data and all following slots in the packet. Am I right? Thank you

Bookmarks

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DMX break timing	majid	RDM Timing Discussion	2	December 30th, 2017 06:15 AM
Summed Break and MAB time	kster	RDM Timing Discussion	4	July 6th, 2009 09:01 PM

All times are GMT -6. The time now is 11:25 PM.