|
RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product. |
|
Thread Tools | Search this Thread | Display Modes |
October 14th, 2011 | #1 |
Member
Join Date: Aug 2011
Posts: 32
|
SENS_GPS
Can I suggest that we add a new sensor type called GPS. This will report the Latitude and Longitude position of the device.
It would also involve adding new unit types for Latitude and Longitude. |
October 14th, 2011 | #2 |
Task Group Member
Join Date: Aug 2008
Posts: 375
|
For a GPS position, you could use two sensors with SENS_ANGLE and UNITS_DEGREE.
Unfortunately, the 16-bit resolution of RDM sensors won't work very well for GPS because of the large scale. Depending on where you are on the earth, you'll only get about 1/2 mile resolution. You could break each value into two sensors, and report the full degree and fractional degree parts separately. |
October 14th, 2011 | #3 |
Member
Join Date: Aug 2011
Posts: 32
|
Would using angle not make it difficult for the software to display it as a Lat / Long and use it? Splitting it up sounds sensible.
I do not know of any lighting device that have GPS but think it is not beyond the bounds of reason that this might happen fairly soon. When you read in LSI of a whole city being lit up a GPS sensor in a fixture does not seem so stupid. |
Bookmarks |
Thread Tools | Search this Thread |
Display Modes | |
|
|