E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM General Implementation Discussion

RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product.

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old July 10th, 2009   #1
jamie
Junior Member
 
Join Date: Jul 2009
Location: Brisbane, Australia
Posts: 3
Default PDL size and manufacturer specific parameter ID's

Greetings,

This is a question regarding an RDM controller generating GET and SET messages for manufacturer specific parameter ID's, based on the information obtained from using the PARAMETER_DESCRIPTION command.

The response to a PARAMETER_DESCRIPTION command includes the "PDL Size" field, which corresponds to GET_RESPONSE and SET PDL sizes, but what about GET and SET_RESPONSE PDL sizes??

Example:
Get/Set DMX Curve command
GET takes in channel (PDL size = 1)
GET_RESPONSE replies with channel and curve (PDL size = 2)
SET takes in channel and curve (PDL size = 2)
SET_RESPONSE replies with no data (PDL size = 0)

So the PDL size field under PARAMETER_DESCRIPTION would be 2 to match GET_RESPONSE and SET, but there is no indication as to how much data to use with GET.

Has anyone come up with a solution/workaround for this?? Note that the controller I'm developing is hand-held with limited firmware, so it's not feasible storing the required information for manufacturer specific id's.

One possible workaround I've thought about is first attempting GET with a PDL size the same as GET_RESPONSE/SET (after allowing the user to set as many data fields as they like up to the GET_RESPONSE/SET PDL size), and if a NACK is received, keep reducing the PDL size of GET until an ACK is received.

Any thoughts on this would be greatly appreciated.

Regards,
Jamie.
Creative Lighting
jamie is offline   Reply With Quote
 

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Command Class / Parameter ID mismatch handling dangeross RDM Interpretation Questions 2 April 16th, 2009 01:39 PM
RDM Discovery - Effect of Manufacturer IDs zshenker RDM General Implementation Discussion 4 April 10th, 2009 02:30 PM


All times are GMT -6. The time now is 03:43 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.