E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM User Forums > RDM User Discussion

RDM User Discussion User level discussion and questions about RDM.

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old April 15th, 2008   #1
svanciel
Junior Member
 
Join Date: Feb 2008
Location: Orlando, FL
Posts: 16
Default DMX robust - RDM not?

Not sure if this comment fits here or under user implementation but I have discovered emperically that DMX is much more robust on a compromised wiring system than the RDM traffic on the same line. A NEMA outdoor, weather rated electrical box, was found to be full of water. The wires and screw terminals on an ETC-pcb mounted on the 4-pin panel xlr were quite corroded. Yet the Aquaram power (pins 1,4) and the DMX data (pins 2,3) were able to get through and power three units and run cues correctly. However, the RDM traffic was occasionally corrupted enough to result in "Dropped Device" messages and no sensor data readings.
I'll now be going through all of the 10 year old terminal boxes to seek out other issues that may be present.

Maybe that others will make this discovery when they try to run RDM products on their "old" DMX systems that have worked well enough in the past? Might be worth noting in an implementation guide.

SteveV
svanciel is offline   Reply With Quote
 

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 04:10 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.