E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM General Implementation Discussion

RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product.

Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old August 27th, 2008   #1
Senior Member
Join Date: Jan 2008
Posts: 102
Default When is a different start code allowed?

Hello all
I have 2 products here that state that they both comply with RDM but when I try to detect the responder with my controller, nothing happens.

In fact, my sniffer does not even detect any RDM packets if these 2 units communicate.
I then looked at the data manually and found a start code that is not 0xCC.

Could someone please clarify when it is allowed to state RDM on a product but use a non RDM start code for all packets?

If this is permissable, then who assigns these other start codes and under what conditions?

Kind Regards
berntd is offline   Reply With Quote


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Sub-device response to SET/GET DMX512 start address p_richart RDM Interpretation Questions 2 September 29th, 2006 09:27 AM
Slot Label Code anstein RDM General Implementation Discussion 1 August 10th, 2006 02:06 PM

All times are GMT -6. The time now is 12:25 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.