Enable/Disable RDM? - E1.20 RDM (Remote Device Management) Protocol Forums

dj41354 · June 16th, 2017

I'm wondering if we should provide the ability for our fixtures to "ignore" RDM. This would be implemented with the User Interface in the back of the fixture and would be a non-volatile setting... so if RDM was disabled, you'd have to physically get to the back of the fixture to re-enable it. Is this a feature that exists on other RDM enabled fixtures?.. and is this considered a helpful thing?.. or not? Thanks in advance for any advice on this.
DougJ

June 16th, 2017	#1
dj41354 Member Join Date: Nov 2015 Posts: 31	Enable/Disable RDM? I'm wondering if we should provide the ability for our fixtures to "ignore" RDM. This would be implemented with the User Interface in the back of the fixture and would be a non-volatile setting... so if RDM was disabled, you'd have to physically get to the back of the fixture to re-enable it. Is this a feature that exists on other RDM enabled fixtures?.. and is this considered a helpful thing?.. or not? Thanks in advance for any advice on this. DougJ

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
new PID suggestion: disable	diane	RDM General Implementation Discussion	5	January 30th, 2014 10:56 AM
Driver Enable Time	luiscolo	RDM Timing Discussion	1	February 7th, 2010 07:34 PM