![]() |
|
RDM Physical Layer/Hardware Discussion Discussion and questions relating to the physical or hardware layer of RDM. |
![]() |
|
Thread Tools | Search this Thread | Display Modes |
![]() |
#1 |
Member
Join Date: Nov 2015
Posts: 31
|
![]()
Hey Eric..
I've been adding some new personalities to our lights and think I've accidentally affected my RDM code. When I try and run Integrity using my DMXter4 with my new firmware, the DMXter says: 0002: DISC MUTE NOISE/DATA w/o BRK at which point Integrity hangs.. Can you tell me what the DMXter might be unhappy with that causes this error message? Thanks.. |
![]() |
![]() |
![]() |
#2 |
Task Group Member
Join Date: Aug 2008
Posts: 375
|
![]()
The controller found your responder via DUB. When it tried to mute the responder, it didn't get a valid response. There was activity on the line during the response period (either noise or data), but there wasn't a valid break beforehand, so the response is not valid.
|
![]() |
![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
DMXter4 says "not responding" | dj41354 | RDM General Implementation Discussion | 11 | November 27th, 2015 06:59 AM |
broadcast Disvovery Mute/Unute | berntd | RDM Interpretation Questions | 2 | April 8th, 2008 10:07 PM |
Mute Response Question | sondericker | RDM Interpretation Questions | 13 | January 21st, 2007 10:14 AM |
Discovery Mute/Un mute | nic123 | RDM Interpretation Questions | 1 | June 14th, 2006 10:28 AM |