|
|
|||||||
| RDM Interpretation Questions Discussion and questions relating to interpreting and understanding the E1.20 RDM Standard. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
October 18th, 2009
|
#1 |
|
Senior Member
Join Date: Jan 2008
Posts: 102
|
CAPTURE_PRESET pdl?
Hello all,
the pdl for this is mentioned as either 2 or 8 but in the text (10.11.8) it mentiones that unused timing fields shall be set to 0. Does this imply that the pdl is always 8? Kidn regards Bernt |
|
|
|
October 18th, 2009
|
#2 |
|
Task Group Member
Join Date: Aug 2008
Posts: 375
|
No, both PDL's are valid.
You might use 0x0000 in one of the timing fields if you have fade times, but no wait time. |
|
|
|
|
October 19th, 2009
|
#3 |
|
Senior Member
Join Date: Jan 2008
Posts: 102
|
Hello,
How does a controller figure out how mane scenes are available in a device? This question also applies to some other commands - I suppose. Kind regards Bernt |
|
|
|
|
October 19th, 2009
|
#4 |
|
Task Group Member
Join Date: Aug 2008
Posts: 375
|
Unfortunately there's no standard way to determine the number of scenes a responder supports, other than getting a NACK when you try and use a scene that the responder doesn't support.
|
|
|
|
|
October 19th, 2009
|
#5 |
|
Administrator
Join Date: Feb 2006
Posts: 433
  |
Eric is correct. I believe we have some new messages that extend this in the Dimmer PID's document we're currently working on that extend the capabilities of Presets.
__________________
Scott M. Blair  RDM Protocol Forums Admin |
|
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
