E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM General Implementation Discussion

RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product.

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old May 5th, 2017   #1
RobbG
Junior Member
 
Join Date: Jan 2015
Posts: 3
Default How to handle DMX Footprint overrun

Hi All,

I've just had an interesting question proposed to me by some other people in my company.

How should a responded behave in a situation where the DMX_START_ADDRESS of a device (root or sub-device) is set to a value greater than (512 - DMX_FOOTPRINT)

Should this behavior be the same for both DMX_START_ADDRESS and DMX_BLOCK_ADDRESS?

My current implementation is an LED driver with 12 sub-devices, each containing 4 channels, if DMX_BLOCK_ADDRESS is used to set the start address of the sub-devices so that any have a DMX_START_ADDRESS above 512 they will set their start addresses to 512. Is there any more guidance on best/recommended practice in this situation?

Thanks in advance,

// Robb
RobbG is offline   Reply With Quote
 

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
How should master handle receiving DMX after sending request? berntd RDM General Implementation Discussion 5 June 30th, 2016 08:59 PM
DMX Addressing when Footprint is Zero Mark_C RDM General Implementation Discussion 8 January 17th, 2010 10:47 AM


All times are GMT -6. The time now is 01:05 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.