E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM Physical Layer/Hardware Discussion

RDM Physical Layer/Hardware Discussion Discussion and questions relating to the physical or hardware layer of RDM.

Reply
 
Thread Tools Search this Thread Display Modes
Old May 25th, 2008   #1
berntd
Senior Member
 
Join Date: Jan 2008
Posts: 102
Default Cable shield connection questions

Hello,

It is pretty cear from the DMX spec that a transmitter must have <20Ohm between shield and chassis and a receiver (non isolated) must have 100Ohm.

This is cool BUT what if a device can be a RDM controller AND a RDM responder, depending on the mode?

Is it expected to switch in and out a 100Ohm resistor?
If it needs to be switched, is there a way to do it without a relay?


Kind regards
Bernt
berntd is offline   Reply With Quote
Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 09:02 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.