E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM General Implementation Discussion

RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product.

Reply
 
Thread Tools Search this Thread Display Modes
Old January 20th, 2007   #1
prwatE120
Task Group Member
 
Join Date: Jun 2006
Posts: 181
Default Discovery Response Preamble

PLEASE remember that a controller is required to cope with a variable number of preamble bytes in responses to Discovery commands.

This is cleary stated in the last paragraph of section 7.5.

Quote:
... The controller shall be able to process response packets with 0-7 bytes of preamble



I have now encountered two controllers that could not cope with this!


This would make them NON-COMPLIANT - but might only show up when they were used in conjunction with one or more layers of splitters.

If you are interested I now have special test responders that can vary the number of preamble bytes returned ...


regards

Peter Willis
prwatE120 is offline   Reply With Quote
Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Incremental Discovery prwatE120 RDM General Implementation Discussion 1 September 29th, 2021 03:18 PM
Mute Response Question sondericker RDM Interpretation Questions 13 January 21st, 2007 10:14 AM
Sub-device response to SET/GET DMX512 start address p_richart RDM Interpretation Questions 2 September 29th, 2006 09:27 AM
Discovery Checksum Problem Analysis nic123 RDM General Implementation Discussion 3 September 24th, 2006 10:25 PM
4.2.1.1 In-line device Port Turnaround during Discovery prwatE120 RDM Timing Discussion 1 August 7th, 2006 10:52 PM


All times are GMT -6. The time now is 08:54 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.