E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM Physical Layer/Hardware Discussion

RDM Physical Layer/Hardware Discussion Discussion and questions relating to the physical or hardware layer of RDM.

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old October 31st, 2013   #1
berntd
Senior Member
 
Join Date: Jan 2008
Posts: 102
Default DMX splitter with Rdm - design

Hello

I am looking at designing a new DMX splitter. The question is whether I can make it RDM compliant or not, given the cost retraints.

Can one have such a splitter without a whole Proxy processor setup?

The only real porblem I see with a real basic solution is switching between tx/rx for each port.

Has anyone done something like this or have any ideas?

Regards
Bernt
berntd is offline   Reply With Quote
 

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Hardware design questions ELMVideo RDM Physical Layer/Hardware Discussion 14 July 21st, 2013 02:52 PM
Anybody actually doing any opensource RDM design percramer RDM General Implementation Discussion 0 September 19th, 2006 11:14 AM


All times are GMT -6. The time now is 04:31 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.