![]() |
|
RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product. |
![]() |
|
Thread Tools | Search this Thread | Display Modes |
![]() |
#1 |
Task Group Member
Join Date: Aug 2006
Posts: 12
|
![]()
I am in the middle of making a simple RDM device which is composed of a conventional lamp integrated with a dimmer. There is a crude current sensing mechanism. It is only intened to determine whether the lamp is good or not. I don't care whether the wattage is 200W or 300W, etc.; just is it there or not.
When reporting the status of the fixture/dimmer, are there any suggestions as to what status message would be most appropriate? The closest entries in the Standard are STS_BREAKER_TRIPPED, STS_WATTS, and STS_DIM_FAILURE. None of these is really a correct description of the error state. Any ideas or experience from others? Regards, Milton Davis |
![]() |
![]() |
![]() |
#2 |
Administrator
|
![]()
Milton,
I think STS_WATTS is probably the closest as you can then report "0 Watts", which would be correct. A Lamp fail message would probably be most useful. This list is meant to easily be extended just by sending a request in to Karl to add a new public one since it sounds like it would be general purpose.
__________________
Scott M. Blair ![]() RDM Protocol Forums Admin |
![]() |
![]() |
![]() |
#3 |
Task Group Member
Join Date: Jun 2006
Posts: 181
|
![]()
Please request a new message STS_LOAD_FAILURE
Peter Willis |
![]() |
![]() |
![]() |
#4 |
Task Group Member
Join Date: Aug 2006
Posts: 12
|
![]()
Thanks Scott/Peter. I will write up a request later today. It's really a little surprising that none of us caught this hole before now... "is it plugged in?"...
Regards, Milton |
![]() |
![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
COMMS_STATUS Error reporting | prwatE120 | RDM Interpretation Questions | 0 | January 20th, 2007 07:07 AM |
Table 6-6 Checksum Example Error | prwatE120 | RDM Interpretation Questions | 1 | January 19th, 2007 06:49 PM |
ACK_TIMER Example Error | prwatE120 | RDM Interpretation Questions | 1 | December 26th, 2006 03:46 PM |
Error counters | Nigel Worsley | RDM Interpretation Questions | 1 | July 3rd, 2006 03:42 PM |