STATUS_NONE response - E1.20 RDM (Remote Device Management) Protocol Forums

kenypp · January 2nd, 2014

How should a responder answer a get status request when there are no status warnings or messages pending? The document is not clear on that. I'm currently using the STATUS_NONE type response with the data fields set to 0. That is nine zeros I believe. The test software I'm using shows this as an unknown status response so it must be expecting something else here. If I respond with a warning like "overtemp" , it shows it as expected. Using Enttec RDM controller BTW.

January 2nd, 2014	#1
kenypp Junior Member Join Date: Jan 2014 Posts: 9	STATUS_NONE response How should a responder answer a get status request when there are no status warnings or messages pending? The document is not clear on that. I'm currently using the STATUS_NONE type response with the data fields set to 0. That is nine zeros I believe. The test software I'm using shows this as an unknown status response so it must be expecting something else here. If I respond with a warning like "overtemp" , it shows it as expected. Using Enttec RDM controller BTW.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode