E1.20 Errate Public Review - E1.20 RDM (Remote Device Management) Protocol Forums

ericthegeek · October 2nd, 2008

Looking over the Errata document that's currently up for public review, I don't understand the following:

> "All GET messages throughout Section 10 should
> show the show the Sub-Device GET range
> stopping at 0xFFFE."

Per section 9.2.1, the Sub Device field can be:

0x0000 for the root device
1-512 (0x0001-0x0200) for sub devices
0xFFFF for sub device all call.

What is 0xFFFE supposed to represent? As I read it, 0x0201 through 0xFFFE are not valid values for the Sub Device field.

sblair · October 5th, 2008

Eric,

Fair enough! I believe that should have been stated as stopping at 0x0200 for GET Commands.

Please submit a Public Review comment on that if you would.

October 2nd, 2008	#1
ericthegeek Task Group Member Join Date: Aug 2008 Posts: 390	E1.20 Errate Public Review Looking over the Errata document that's currently up for public review, I don't understand the following: > "All GET messages throughout Section 10 should > show the show the Sub-Device GET range > stopping at 0xFFFE." Per section 9.2.1, the Sub Device field can be: 0x0000 for the root device 1-512 (0x0001-0x0200) for sub devices 0xFFFF for sub device all call. What is 0xFFFE supposed to represent? As I read it, 0x0201 through 0xFFFE are not valid values for the Sub Device field.

October 5th, 2008	#2
sblair Administrator Join Date: Feb 2006 Posts: 441	Eric, Fair enough! I believe that should have been stated as stopping at 0x0200 for GET Commands. Please submit a Public Review comment on that if you would. __________________ Scott M. Blair RDM Protocol Forums Admin

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode