PARAMETER_DESCRIPTION - E1.20 RDM (Remote Device Management) Protocol Forums

pkleissler · September 26th, 2018

Hi Jim,

The DMXcat does indeed support PARAMETER_DESCRIPTION. If a device has Mfg specific PID(s), there will be a tab on the bottom of the screen for that device named MANUF. SETTINGS. It will then load the parameter descriptions for each and display them as a list.

It also supports ETCs enumerated text Mfg Specific PID to convert enumerations to text.

Sub devices are also fully supported. As well as a good portion of 1.37-x PIDs.

Paul Kleissler
Head of Engineering

City Theatrical
201-549-1160

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Usage of PARAMETER_DESCRIPTION for manufacturer-specific PIDs	R.Schladör	RDM General Implementation Discussion	9	September 26th, 2018 12:04 PM
PARAMETER_DESCRIPTION data type semantics	tim_ecue	RDM Interpretation Questions	4	October 14th, 2009 10:47 AM

September 26th, 2018	#1
pkleissler Task Group Member Join Date: Oct 2008 Location: NJ Posts: 19	Hi Jim, The DMXcat does indeed support PARAMETER_DESCRIPTION. If a device has Mfg specific PID(s), there will be a tab on the bottom of the screen for that device named MANUF. SETTINGS. It will then load the parameter descriptions for each and display them as a list. It also supports ETCs enumerated text Mfg Specific PID to convert enumerations to text. Sub devices are also fully supported. As well as a good portion of 1.37-x PIDs. Paul Kleissler Head of Engineering City Theatrical 201-549-1160