Sensor Defintion/Support Parameters - E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums

		E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM General Implementation Discussion
Sensor Defintion/Support Parameters

Mark Forums Read

RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product.

Reply

Search this Thread

September 1st, 2016	#1
ericthegeek Task Group Member Join Date: Aug 2008 Posts: 390	Sensors are numbered 0x00 – 0xFE, so zero is a valid value for Data Value 1 in the status messages.

Reply

Bookmarks

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
QUEUED_MESSAGE - must controllers support this?	berntd	RDM General Implementation Discussion	4	December 11th, 2024 08:53 AM
Sensor type and Sensor unit for No of Phases question	berntd	RDM General Implementation Discussion	1	October 1st, 2009 10:04 PM
Sensor type and Sensor unit for DMX rate question	berntd	RDM General Implementation Discussion	3	October 1st, 2009 12:41 AM
DMX/RDM support in new SBC	tracyu	RDM Marketplace Discussion	0	June 2nd, 2008 05:57 PM

All times are GMT -6. The time now is 04:32 PM.