RS485 Tranceiver IC's RX Pin - E1.20 RDM (Remote Device Management) Protocol Forums

ericthegeek · March 27th, 2015

Seems like it must be a bug in the controller. Get in touch with them and see if they can look into it.

BTW: The Manufacturer Label should be the Name of the manufacturer and not a URL. We're planning to add the ability to get the URL in the E1.37-5 document which is being written by the RDM Task Group right now.

StephenYim · March 27th, 2015

Dear ericthegeek,

Thanks. About the Manufacturer Label, I just believe a single URL will provide much more info for the user,thanks

.

March 27th, 2015	#2
StephenYim Junior Member Join Date: Mar 2015 Posts: 11	Dear ericthegeek, Thanks. About the Manufacturer Label, I just believe a single URL will provide much more info for the user,thanks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
RS485 networking	tracyu	RDM Physical Layer/Hardware Discussion	0	June 11th, 2008 05:54 PM

March 27th, 2015	#1
ericthegeek Task Group Member Join Date: Aug 2008 Posts: 390	Seems like it must be a bug in the controller. Get in touch with them and see if they can look into it. BTW: The Manufacturer Label should be the Name of the manufacturer and not a URL. We're planning to add the ability to get the URL in the E1.37-5 document which is being written by the RDM Task Group right now.