RS485 Tranceiver IC's RX Pin - E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums

		E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM Physical Layer/Hardware Discussion
RS485 Tranceiver IC's RX Pin

Mark Forums Read

RDM Physical Layer/Hardware Discussion Discussion and questions relating to the physical or hardware layer of RDM.

Reply

Search this Thread

March 26th, 2015	#1
StephenYim Junior Member Join Date: Mar 2015 Posts: 11	Thanks ericthegeek. I will check if controller had sent SENSOR_DEFINITION/SENSOR_VALUE commands. thanks again.

Reply

Bookmarks

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
RS485 networking	tracyu	RDM Physical Layer/Hardware Discussion	0	June 11th, 2008 05:54 PM

All times are GMT -6. The time now is 03:22 PM.