|
|
|||||||
| RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product. |
|
|
Thread Tools | Search this Thread | Display Modes |
March 12th, 2014
|
#22 |
|
Task Group Member
Join Date: Aug 2008
Posts: 390
|
RDM only uses SI units for sensors. But, controllers can easily convert the sensor data and display it in whatever unit makes sense for its users.
For example, a controller that's configured for US Localization might convert units to Feet/Pounds/Farenheight when displaying sensors, but use Meters/Kilograms/Centigrade everywhere else. |
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| QUEUED_MESSAGE - must controllers support this? | berntd | RDM General Implementation Discussion | 4 | December 11th, 2024 08:53 AM |
| Sensor type and Sensor unit for No of Phases question | berntd | RDM General Implementation Discussion | 1 | October 1st, 2009 10:04 PM |
| Sensor type and Sensor unit for DMX rate question | berntd | RDM General Implementation Discussion | 3 | October 1st, 2009 12:41 AM |
| DMX/RDM support in new SBC | tracyu | RDM Marketplace Discussion | 0 | June 2nd, 2008 05:57 PM |
Threaded Mode