|
|
|||||||
| RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product. |
|
|
Thread Tools | Search this Thread | Display Modes |
February 16th, 2014
|
#17 |
|
Junior Member
Join Date: Feb 2014
Location: Brisbane,Australia
Posts: 15
|
Hi Eric,
Thanks for that information. We have got the system to monitor the sensors, set max and min opertation temperature and also do the remaining basic information such as Discovery,identify, set/get DMX address, Software version,supported parameters, sensor definition, sensor value, and now currentley working on status message. we believe that section 6.2 explains all that we where looking for. we shall have a play with it and let you know how we go. Thanks a lot for the support. Regards George |
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| QUEUED_MESSAGE - must controllers support this? | berntd | RDM General Implementation Discussion | 4 | December 11th, 2024 08:53 AM |
| Sensor type and Sensor unit for No of Phases question | berntd | RDM General Implementation Discussion | 1 | October 1st, 2009 10:04 PM |
| Sensor type and Sensor unit for DMX rate question | berntd | RDM General Implementation Discussion | 3 | October 1st, 2009 12:41 AM |
| DMX/RDM support in new SBC | tracyu | RDM Marketplace Discussion | 0 | June 2nd, 2008 05:57 PM |
Threaded Mode