|
|
|||||||
| RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
|
February 3rd, 2014
|
#1 |
|
Junior Member
Join Date: Feb 2014
Location: Brisbane,Australia
Posts: 15
|
Hi Scott,
How are you? We got the entire system working in the way of sensors. while using the RDM controller it had the option on its user interphase which said STATUS MESSAGE. I had hard coded the GET SENSOR VALUE to a value more than the normal value(which was defined in the SUPPORT PARAMETERS) but the STATUS MESSAGE would not show a thing. would that mean I have to write a pice of code to reply to STATUS message? I also looked into STATUS MESSAGE(10.3.2) but in its Responce it had "Sub-Device ID". Now the question become how do I specify it is the sensor and not a sub device? Looking forward to hearing soon. Thanks once again in advance..  Regards George |
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| QUEUED_MESSAGE - must controllers support this? | berntd | RDM General Implementation Discussion | 4 | December 11th, 2024 08:53 AM |
| Sensor type and Sensor unit for No of Phases question | berntd | RDM General Implementation Discussion | 1 | October 1st, 2009 10:04 PM |
| Sensor type and Sensor unit for DMX rate question | berntd | RDM General Implementation Discussion | 3 | October 1st, 2009 12:41 AM |
| DMX/RDM support in new SBC | tracyu | RDM Marketplace Discussion | 0 | June 2nd, 2008 05:57 PM |
Hybrid Mode
