|
|
|||||||
| RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product. |
|
|
Thread Tools | Search this Thread | Display Modes |
February 2nd, 2014
|
#6 |
|
Administrator
Join Date: Feb 2006
Posts: 441
  |
The 2nd to last paragraph of Section 10.7 covers sensor addressing.
Sensors are consecutively numbered starting from 0. The request message from the controller will specify which sensor number it is requesting the definition or value of.
__________________
Scott M. Blair  RDM Protocol Forums Admin |
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| QUEUED_MESSAGE - must controllers support this? | berntd | RDM General Implementation Discussion | 4 | December 11th, 2024 08:53 AM |
| Sensor type and Sensor unit for No of Phases question | berntd | RDM General Implementation Discussion | 1 | October 1st, 2009 10:04 PM |
| Sensor type and Sensor unit for DMX rate question | berntd | RDM General Implementation Discussion | 3 | October 1st, 2009 12:41 AM |
| DMX/RDM support in new SBC | tracyu | RDM Marketplace Discussion | 0 | June 2nd, 2008 05:57 PM |
Threaded Mode