|
|
|||||||
| RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product. |
|
|
Thread Tools | Search this Thread | Display Modes |
December 8th, 2013
|
#2 |
|
Administrator
Join Date: Feb 2006
Posts: 441
  |
Daryl,
Welcome to the forums! The first thing I would normally say is check your timings! But it sounds like you've covered that. If you're sure all the timings are good, then lets move on to the data. You said you were trying to use it through their API to your own software on Windows. Can you confirm if you just use the Enttec Controller Software if it is decoding and displaying the response properly? If so, then it may be an issue in their API or your interface to it. Otherwise if the Enttec controller app is not displaying the response then I'd suggest sending us a full dump of both the GET packed from the controller that you are receiving in your fixture and then the exact data you are responding back to it with including checksum and everything that way some of us can look through it and see if we spot anything. Scott
__________________
Scott M. Blair  RDM Protocol Forums Admin |
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| JESE DMX-TRI RDM USB Controller | hamish | RDM Marketplace Discussion | 4 | January 6th, 2020 05:59 PM |
| Uniquely defining the RDM response of devices | Andy Macdonald | RDM General Implementation Discussion | 6 | February 9th, 2009 02:24 PM |
| ENTTEC RDM controller (subdevices) | nic123 | RDM Marketplace Discussion | 3 | October 24th, 2007 12:03 AM |
| ENTTEC RDM Library | nic123 | RDM Marketplace Discussion | 0 | October 5th, 2006 03:23 PM |
| ENTTEC RDM Software Available | nic123 | RDM Marketplace Discussion | 0 | August 4th, 2006 01:38 AM |
Threaded Mode