Discovery procedure clarification - E1.20 RDM (Remote Device Management) Protocol Forums

truten · March 21st, 2013

Dear Scott, thank you.

It's clear that I misread or I didn't fully understand the ANSI correctly since I thought that once the responder was muted it shouldn't respond until it was unmuted with the proper command...
Big mistake.

Now the discovery make more sense

Regarding the Goddard I'm quite sure that it send a RESET_DEVICE when in the RDM discovery menu you choose to mute a specific device.
Anyway this will not be a problem any-more since it should be solved as soon I fix the discovery.

Again thank you.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
RDM Controller timing clarification	Dan Scheurell	RDM Timing Discussion	4	May 15th, 2014 10:34 PM

March 21st, 2013	#1
truten Junior Member Join Date: Mar 2013 Posts: 2	Dear Scott, thank you. It's clear that I misread or I didn't fully understand the ANSI correctly since I thought that once the responder was muted it shouldn't respond until it was unmuted with the proper command... Big mistake. Now the discovery make more sense Regarding the Goddard I'm quite sure that it send a RESET_DEVICE when in the RDM discovery menu you choose to mute a specific device. Anyway this will not be a problem any-more since it should be solved as soon I fix the discovery. Again thank you.