Trying to run the automated tests

[ericthegeek]

Originally Posted by LaurentG

Everything is working fine with the Enttec controller.
I'm assuming the UID is properly encoded in the DUB packet, but I'm gonna check that again.

That's not necessarily a valid assumption. I don't recall how the Enttec software handles discovery, but there are controllers out there that will add a responder to the table of discovered devices based solely on a DUB request with a single UID range (the same UID in both the lower and upper bounds).

Some controllers will even add a device if the mute request times out.

Both of these are undesirable behavior, but they do exist.