Sub Device required PIDs - E1.20 RDM (Remote Device Management) Protocol Forums

ericthegeek · May 1st, 2012

On other factor that's come up in newer discussions is that Sub-Devices should list all of their PIDs in SUPPORTED_PARAMETERS, even PIDs like DEVICE_INFO that are mandatory and not listed in SUPPORTED_PARAMETERS for root devices.

The gray area is whether sub-devices should include SUPPORTED_PARAMETERS in the list returned by GET SUPPORTED_PARAMETERS. My opinion is *no* since SUPPORTED_PARAMETERS is explicitly required by section 9.2.3.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Required handling of sequences of RDM broadcast cmds	eldoMS	RDM Timing Discussion	9	August 23rd, 2011 09:40 AM
Is there a minimum required PID list for sub-devices?	p_richart	RDM Interpretation Questions	4	November 7th, 2008 01:04 PM

May 1st, 2012	#9
ericthegeek Task Group Member Join Date: Aug 2008 Posts: 390	On other factor that's come up in newer discussions is that Sub-Devices should list all of their PIDs in SUPPORTED_PARAMETERS, even PIDs like DEVICE_INFO that are mandatory and not listed in SUPPORTED_PARAMETERS for root devices. The gray area is whether sub-devices should include SUPPORTED_PARAMETERS in the list returned by GET SUPPORTED_PARAMETERS. My opinion is no since SUPPORTED_PARAMETERS is explicitly required by section 9.2.3.