|
|
|||||||
| RDM Timing Discussion Discussion and questions relating to the timing requirements of RDM. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
|
May 8th, 2009
|
#1 |
|
Junior Member
Join Date: Feb 2009
Posts: 7
|
inter-slot timeout
"Responders may consider controller packets with inter-slot delays of 2.1mS or greater to be lost"...
So, every USB/DMX PC interface which outputs packets directly (whithout esternal buffering & retrasmission circuit) may be cause packets to be lost, due the time scheduling of the operating system (for windows tipically >10ms). In my RDM-responder firmware I set up the inter-slot delay timeout equal to the packet timeout equal to 1S. Is it a valid solution? |
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Packet Captures? | jhuntington | RDM General Implementation Discussion | 0 | March 4th, 2007 07:19 PM |
| Any RDM Responder Devices out there yet? | sblair | RDM Marketplace Discussion | 8 | September 20th, 2006 06:03 AM |
Hybrid Mode
