|
|
|||||||
| RDM Physical Layer/Hardware Discussion Discussion and questions relating to the physical or hardware layer of RDM. |
|
|
Thread Tools | Search this Thread | Display Modes |
August 5th, 2008
|
#5 |
|
Junior Member
Join Date: Jun 2006
Location: London
Posts: 13
|
A capacitor after the diode will sort out the impedance issue, it doesn't need to be particularly large as the impedance is only relevant for higher frequencies - 100nF would probably be enough. Add a zener across it to prevent it charging up too much and changing the bias voltage.
BTW, 3.3V tranzorbs ARE available, NXP, Vishay and ST all do them. Last edited by Nigel Worsley; August 5th, 2008 at 06:17 AM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3.3V Biasing | William CANO | RDM Physical Layer/Hardware Discussion | 3 | December 5th, 2006 07:17 AM |
| Line biasing | Andy Macdonald | RDM Physical Layer/Hardware Discussion | 1 | October 26th, 2006 11:02 AM |
| 4.2.1.1 In-line device Port Turnaround during Discovery | prwatE120 | RDM Timing Discussion | 1 | August 7th, 2006 10:52 PM |
Threaded Mode