Mute Response Question - E1.20 RDM (Remote Device Management) Protocol Forums

sondericker · July 24th, 2006

Hi Scott,

Yes, I believe I have seen this occur. It stumped us for a few days in fact. It happens if you have just the right 3 UID's that are numerically close to one another. The "wire-or" that makes A&B look like C changes the checksum perfectly, as it is only one bit that changes in the message and one bit that changes in the checksum. A's UID is one bit off of that of C and B's UID is also one bit off of C. We're using a very high speed processor with interrupt driven serial algorithms so the response synchronization across multiple responders is very tight.

We'll deal with it by having the controller notice when its happening and continue to branch. I hope -- unless I'm totally mistaken somehow -- that this thread will some day save someone some frustration.

-John Sondericker
Wybron, inc.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
broadcast Disvovery Mute/Unute	berntd	RDM Interpretation Questions	2	April 8th, 2008 10:07 PM
Discovery Response Preamble	prwatE120	RDM General Implementation Discussion	0	January 20th, 2007 12:22 AM
Sub-device response to SET/GET DMX512 start address	p_richart	RDM Interpretation Questions	2	September 29th, 2006 09:27 AM
Discovery Mute/Un mute	nic123	RDM Interpretation Questions	1	June 14th, 2006 10:28 AM

July 24th, 2006	#5
sondericker Banned Join Date: Jun 2006 Posts: 11	Hi Scott, Yes, I believe I have seen this occur. It stumped us for a few days in fact. It happens if you have just the right 3 UID's that are numerically close to one another. The "wire-or" that makes A&B look like C changes the checksum perfectly, as it is only one bit that changes in the message and one bit that changes in the checksum. A's UID is one bit off of that of C and B's UID is also one bit off of C. We're using a very high speed processor with interrupt driven serial algorithms so the response synchronization across multiple responders is very tight. We'll deal with it by having the controller notice when its happening and continue to branch. I hope -- unless I'm totally mistaken somehow -- that this thread will some day save someone some frustration. -John Sondericker Wybron, inc.