Support a given PID with a GET but not a SET - E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums

		E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM Interpretation Questions
Support a given PID with a GET but not a SET

RDM Interpretation Questions Discussion and questions relating to interpreting and understanding the E1.20 RDM Standard.

Search this Thread

Prev

Previous Post

Next Post

Next

February 25th, 2014	#1
LarryDew Junior Member Join Date: Aug 2013 Posts: 4	Support a given PID with a GET but not a SET For a given PID, if I support the GET must I support the SET. Example IDENTIFY_MODE: GET returns QUITE but I don't not have a LOUD setting so setting it to LOUD does nothing. Should I return a NR_DATA_OUT_OF RANGE or NR_UNSUPPORTED_CC? In general, if I am testing for a supported PID is it required to support both GET and SET command classes? Thanks

Bookmarks

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ACT_TIMER to Set messages	nic123	RDM Interpretation Questions	3	April 18th, 2014 12:01 PM
DMX_BLOCK_ADDRESS (Set)	hamish	RDM Interpretation Questions	7	June 26th, 2013 02:53 AM
Sub-device response to SET/GET DMX512 start address	p_richart	RDM Interpretation Questions	2	September 29th, 2006 09:27 AM

All times are GMT -6. The time now is 02:36 PM.