Discovery response not recognized - E1.20 RDM (Remote Device Management) Protocol Forums

sblair · January 13th, 2022

Welcome to the forums!

A couple random thoughts of things I've ran into before to also check:

- Could be a timing issue in the response. Make sure everything is within the right timing window.
- You might need to leave some additional time between sending the packet and shutting off the Tx drive. It is super easy to disable TX before the packet has fully been sent chopping off some bits at the end and causing the behavior you are seeing.

Scott

January 13th, 2022	#4
sblair Administrator Join Date: Feb 2006 Posts: 441	Welcome to the forums! A couple random thoughts of things I've ran into before to also check: - Could be a timing issue in the response. Make sure everything is within the right timing window. - You might need to leave some additional time between sending the packet and shutting off the Tx drive. It is super easy to disable TX before the packet has fully been sent chopping off some bits at the end and causing the behavior you are seeing. Scott __________________ Scott M. Blair RDM Protocol Forums Admin

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Discovery response format	FishFood6	RDM General Implementation Discussion	5	November 19th, 2020 06:15 AM
Discovery Response Preamble	prwatE120	RDM General Implementation Discussion	0	January 20th, 2007 12:22 AM