|
|
|||||||
| RDM Interpretation Questions Discussion and questions relating to interpreting and understanding the E1.20 RDM Standard. |
|
|
Thread Tools | Search this Thread | Display Modes |
April 4th, 2014
|
#1 |
|
Junior Member
Join Date: Mar 2014
Posts: 8
|
PRESET_PLAYBACK of a non programmed Scene
Hi,
what is supposed to do a responder device if the controller send a PRESET_PLAYBACK command with a Scene number supported but not programmed? - Answare NACK_OUT_OF_RANGE and stays in the current status: probably this is the right behaviour if the Scene number is out of supported range - Answare ACK and stays in the current status: in this case the controller doesn't see any error and thinks everything is ok - Any other possibility? If controller implements the E1.37 it should know if a scene is programmed throught PRESET_STATUS command, but only few controller are compliant with E1.37! Any suggestion? |
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PRESET_PLAYBACK and Non volatile memory | docsale | RDM General Implementation Discussion | 1 | April 1st, 2014 02:31 AM |
| PRESET_PLAYBACK | berntd | RDM Interpretation Questions | 1 | October 18th, 2009 11:14 PM |
Threaded Mode