|
|
|||||||
| RDM General Implementation Discussion General Discussion and questions relating to implementing RDM in a product. |
|
|
Thread Tools | Search this Thread | Display Modes |
December 9th, 2013
|
#6 |
|
Junior Member
Join Date: Nov 2011
Location: Phuket, Thailand
Posts: 7
|
Thanks ericthegeek, you are correct, I am using the USB protocol and forming the entire packet myself. I came to the same conclusion that I need to add the UID of the Enttec device. I am confused as to why that is even necessary because it would not receive any packets back from any other UID, except the broadcast one, so what is the point of allowing me to add a different one? Except in the case where I was pretending to be some other controller.
|
|
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| JESE DMX-TRI RDM USB Controller | hamish | RDM Marketplace Discussion | 4 | January 6th, 2020 05:59 PM |
| Uniquely defining the RDM response of devices | Andy Macdonald | RDM General Implementation Discussion | 6 | February 9th, 2009 02:24 PM |
| ENTTEC RDM controller (subdevices) | nic123 | RDM Marketplace Discussion | 3 | October 24th, 2007 12:03 AM |
| ENTTEC RDM Library | nic123 | RDM Marketplace Discussion | 0 | October 5th, 2006 03:23 PM |
| ENTTEC RDM Software Available | nic123 | RDM Marketplace Discussion | 0 | August 4th, 2006 01:38 AM |
Threaded Mode