Sensor type and Sensor unit for No of Phases question - E1.20 RDM (Remote Device Management) Protocol Forums

berntd · October 1st, 2009

Hello again,

Here is another one,
What sensor type and units should I use for the number of active mains phases?

I can't see anything obviously suitable by just looking at Tables A-12/A-13.

Kind reagdrs
Bernt

ericthegeek · October 1st, 2009

Is it a device where you expect the number of phases to change on a regular basis (like a dimmer pack that can be wired for single phase or three phase)?

You could have multiple voltage sensors, and report the voltage for each input phase separately.

Or, SENS_OTHER and a Manufacturer-Specific Unit along with a well-written text string should work for most controllers.

October 1st, 2009	#1
berntd Senior Member Join Date: Jan 2008 Posts: 102	Sensor type and Sensor unit for No of Phases question Hello again, Here is another one, What sensor type and units should I use for the number of active mains phases? I can't see anything obviously suitable by just looking at Tables A-12/A-13. Kind reagdrs Bernt

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Additional Sensor Unit Defines - Table A13	prwatE120	RDM General Implementation Discussion	5	October 1st, 2009 10:49 AM
Sensor type and Sensor unit for DMX rate question	berntd	RDM General Implementation Discussion	3	October 1st, 2009 12:41 AM
Reset sensor data of all sensors	sjackman	RDM Interpretation Questions	1	January 20th, 2008 06:47 PM
Sensor string tables	sjackman	RDM General Implementation Discussion	0	September 28th, 2006 05:16 PM

October 1st, 2009	#2
ericthegeek Task Group Member Join Date: Aug 2008 Posts: 390	Is it a device where you expect the number of phases to change on a regular basis (like a dimmer pack that can be wired for single phase or three phase)? You could have multiple voltage sensors, and report the voltage for each input phase separately. Or, SENS_OTHER and a Manufacturer-Specific Unit along with a well-written text string should work for most controllers.