DMX splitter with Rdm - design - E1.20 RDM (Remote Device Management) Protocol Forums

E1.20 RDM (Remote Device Management) Protocol Forums

		E1.20 RDM (Remote Device Management) Protocol Forums > RDM Developer Forums > RDM Physical Layer/Hardware Discussion
DMX splitter with Rdm - design

RDM Physical Layer/Hardware Discussion Discussion and questions relating to the physical or hardware layer of RDM.

Search this Thread

Prev

Previous Post

Next Post

Next

October 31st, 2013	#1
berntd Senior Member Join Date: Jan 2008 Posts: 102	DMX splitter with Rdm - design Hello I am looking at designing a new DMX splitter. The question is whether I can make it RDM compliant or not, given the cost retraints. Can one have such a splitter without a whole Proxy processor setup? The only real porblem I see with a real basic solution is switching between tx/rx for each port. Has anyone done something like this or have any ideas? Regards Bernt

Bookmarks

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Hardware design questions	ELMVideo	RDM Physical Layer/Hardware Discussion	14	July 21st, 2013 02:52 PM
Anybody actually doing any opensource RDM design	percramer	RDM General Implementation Discussion	0	September 19th, 2006 11:14 AM

All times are GMT -6. The time now is 02:08 PM.