Hi Scott,
i have developed some RDM features in our fixture.
The supported PIS are: GET SUP. PAR, DMX START ADRESS, DEVICE MODEL, MANUFACTURER LABEL, DEVICE LABEL, SENSOR DEFINITION, SENSOR VALUE, DEVICE HOURS, LAMP HOURS, LAMP STRIKES, DISPLAY INVERT, DISPLAY LEVEL, PAN INVERT, TILT INVERT, DEVICE RESET, IDENTIFY DEVICE, DMX512 PERSONALITY, DMX512 PERSONALITY DERSCRIPTION, STATUS MESSAGES, STATUS MESSAGES DESCRIPTION, LAMP STATE, LAMP ON MODE,
+ required PIDs
I have developed a testing software to(under Linux), which is able to discovery fixtures on the DMX network, "scan" fixtures and their status, set and gfet supported paramethers. For the communication is used a little bit upgraded ENTTEC open DMX USB converter. I have developed this RDm features in according to the "BSR E1.20 RDM Revision 3.0a CP/2003-1003r3". There is the start code defined as 0xF0.
Now I'm testing the ENTTEC USB PRO, wich used the start code 0xCC.
Tomas
|