Quote:
Originally Posted by LaurentG
Everything is working fine with the Enttec controller.
I'm assuming the UID is properly encoded in the DUB packet, but I'm gonna check that again.
|
That's not necessarily a valid assumption. I don't recall how the Enttec software handles discovery, but there are controllers out there that will add a responder to the table of discovered devices based solely on a DUB request with a single UID range (the same UID in both the lower and upper bounds).
Some controllers will even add a device if the mute request times out.
Both of these are undesirable behavior, but they do exist.