View Single Post
Old December 13th, 2016   #3
dgaller
Junior Member
 
Join Date: Dec 2016
Posts: 5
Default

Quote:
Originally Posted by sblair View Post
Welcome!

In your specific case, you've got a DMX decoder that does support RDM, so presumably that would let you set starting address and maybe a few other parameters. But, that is just converting the DMX signal to 0-24V to drive the LED strips. There really is no intelligence beyond the output of the DMX decoder since it is just analog drive. All the intelligence is located in the DMX decoder which is where the RDM support is actually needed. There is no logic or intelligence in the analog LED strips that you would be able to get any info back from anyway.
Aha, so basically the DECODER reports the status of itself back to the ENGINE. BUT, if the decoder sends its PWM signals out the "analog" side (12v/24v), the fixture attached on the analog side obviously cannot report what it's doing since it's just regulating power to change colors, is that correct?

If that's the case, how can RDM report what it's doing if it really doesn't know how well the fixture is responding? For example, wouldn't it report inaccurate information if, say, there IS no fixture attached to the decoder?
dgaller is offline   Reply With Quote