View Single Post
Old December 8th, 2013   #2
sblair
Administrator
 
Join Date: Feb 2006
Posts: 433
Send a message via AIM to sblair Send a message via MSN to sblair
Default

Daryl,

Welcome to the forums! The first thing I would normally say is check your timings! But it sounds like you've covered that. If you're sure all the timings are good, then lets move on to the data.

You said you were trying to use it through their API to your own software on Windows. Can you confirm if you just use the Enttec Controller Software if it is decoding and displaying the response properly? If so, then it may be an issue in their API or your interface to it.

Otherwise if the Enttec controller app is not displaying the response then I'd suggest sending us a full dump of both the GET packed from the controller that you are receiving in your fixture and then the exact data you are responding back to it with including checksum and everything that way some of us can look through it and see if we spot anything.

Scott
__________________
Scott M. Blair
RDM Protocol Forums Admin
sblair is offline   Reply With Quote