View Single Post
Old November 8th, 2018   #1
Junior Member
Join Date: Jan 2014
Location: Treviso, Italy
Posts: 13
Default BREAK timing at the receiver

This is the my question: can a DMX receiver consider a signal low level lower than 88us as a BREAK?
If the answer in NO, this is a framing error (stop bit error): in this case may the receiver accept previous slots of the frame?
DMX512-A 9.1 says it must only discard improperly framed slot data and all following slots in the packet.
Am I right?

Thank you
zano_villa is offline   Reply With Quote