E1.20 RDM (Remote Device Management) Protocol Forums  

Go Back   E1.20 RDM (Remote Device Management) Protocol Forums > Search Forums

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: dfleenor
Forum: RDM General Implementation Discussion February 28th, 2007
Replies: 1
Views: 11,016
Posted By dfleenor
RDM PLUGFEST LONDON

Anyone know the shipping address for equipment going to the March 5th plugfest at earls court london?
Forum: RDM Interpretation Questions July 28th, 2006
Replies: 13
Views: 22,936
Posted By dfleenor
The only controller I've written is the RAD which...

The only controller I've written is the RAD which always goes to the bottom of the tree. If this problem occurs on fast-discovery we should probably write up a description and add it to our knowledge...
Forum: RDM Marketplace Discussion July 6th, 2006
Replies: 1
Views: 13,620
Posted By dfleenor
RDM products from Doug Fleenor Design...

RDM products from Doug Fleenor Design (www.dfd.com (http://www.dfd.com)):

RDM Coffee Pot implements the minimum required PIDs. MSRP $100 plus shipping.

RAD (remote addressing device)...
Forum: RDM Marketplace Discussion July 6th, 2006
Replies: 8
Views: 19,118
Posted By dfleenor
RDM Coffee Pot supports minimum PIDs

The coffee pot is a minimal implementation. Code fits in a 1K PIC. Queued Messages are not generated/supported. There are no status messages generated.

All PIDs that are not supported are...
Forum: RDM Marketplace Discussion June 29th, 2006
Replies: 8
Views: 19,118
Posted By dfleenor
RDM COFFEE POT NOW SHIPPING WITH NEW START CODE

The RDM Coffee Pot is now shipping with the new start code and is fully compliant with the released spec (we think).
Forum: RDM Marketplace Discussion June 21st, 2006
Replies: 0
Views: 9,675
Posted By dfleenor
Hi Everyone. I just joined the Forum. I will...

Hi Everyone. I just joined the Forum. I will try to log in every other day or so to check this thread for questions. We've had a Bi-Directional splitter for three years now which works with RDM as...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -6. The time now is 10:32 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.