Forum: RDM General Implementation Discussion
February 6th, 2009
|
Replies: 6
Views: 14,728
Eric,
I completely agree that you can make...
Eric,
I completely agree that you can make assumptions, and that if you're just trying to select the correct fixture personality you won't need to know the software version or RDM protocol...
|
Forum: RDM General Implementation Discussion
February 5th, 2009
|
Replies: 6
Views: 14,728
|
Forum: RDM General Implementation Discussion
February 5th, 2009
|
Replies: 6
Views: 14,728
Uniquely defining the RDM response of devices
If a controller discovers two devices which respond with the same
- Manufacturer ID
- RDM protocol version
- Device Model ID
- Software Version ID
- DMX512 Personality
is it correct to say that...
|
Forum: RDM Physical Layer/Hardware Discussion
October 20th, 2006
|
Replies: 1
Views: 13,168
Line biasing
Scott,
I'm sure you're busy at LDI, but when you're back in the office and have a moment, could you explain a little of the background to line biasing please. What is it used for/why does it...
|
Forum: RDM Interpretation Questions
October 16th, 2006
|
Replies: 4
Views: 13,537
Scott,
Thanks for your reply, and apologies...
Scott,
Thanks for your reply, and apologies for the delay in following it up.
Para 9.2.3 of the spec says "all sub-devices shall report an identical list for SUPPORTED_PARAMETERS". I presume...
|
Forum: RDM Interpretation Questions
October 5th, 2006
|
Replies: 4
Views: 13,537
Device Models
This may seem a little obvious, but I wanted to check what people understand by the term "Model" in an RDM context? It's not mentioned in Appendix D (Definitions). I ask because of the requirement in...
|