E1.20 RDM (Remote Device Management) Protocol Forums

		E1.20 RDM (Remote Device Management) Protocol Forums > Search Forums
Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: ericthegeek

Forum: RDM Interpretation Questions

December 17th, 2018

Replies: 16

How should a device with footprint=0 respond to setting the DMX start address?

Views: 21,707

Posted By ericthegeek

Fully agree. You probably noticed that I didn't...

Fully agree. You probably noticed that I didn't include every NACK Reason code in my category list because, as you point out, there are varying degrees of finality.

Please don't think I'm...

Forum: RDM Interpretation Questions

December 16th, 2018

Replies: 16

How should a device with footprint=0 respond to setting the DMX start address?

Views: 21,707

Posted By ericthegeek

Peter, There can be endless battles...

Peter,

There can be endless battles about which NACK Reason Code to use in a myriad of situations. There's no "right" answer to many of those cases. This is especially true when looking at...

Forum: RDM Interpretation Questions

December 10th, 2018

Replies: 16

How should a device with footprint=0 respond to setting the DMX start address?

Views: 21,707

Posted By ericthegeek

I'd suggest using NR_UNKNOWN_PID for GET also for...

I'd suggest using NR_UNKNOWN_PID for GET also for the reason you mention (symmetry), but either behavior is OK.

You will need to use 0xFFFF in the Device Info Response since that field is always...

Forum: RDM Interpretation Questions

December 3rd, 2018

Replies: 16

How should a device with footprint=0 respond to setting the DMX start address?

Views: 21,707

Posted By ericthegeek

IMO using NR_ACTION_NOT_SUPPORTED is a very bad...

IMO using NR_ACTION_NOT_SUPPORTED is a very bad idea.

That NACK Reason code was not defined until E1.37-2 in 2014. Many controllers (especially older controllers and those that have not...

Forum: RDM Interpretation Questions

December 3rd, 2018

Replies: 16

How should a device with footprint=0 respond to setting the DMX start address?

Views: 21,707

Posted By ericthegeek

NR_UNKNOWN_PID

NR_UNKNOWN_PID

Forum: RDM Interpretation Questions

December 3rd, 2018

Replies: 16

How should a device with footprint=0 respond to setting the DMX start address?

Views: 21,707

Posted By ericthegeek

Most controllers won't display the UI that allows...

Most controllers won't display the UI that allows you to set the DMX address when the responder has a zero slot footprint. This means you won't even be able to send the SET request most of the time....

Showing results 1 to 6 of 6

All times are GMT -6. The time now is 12:15 AM.